Can-Am Commander Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
My commander sat for 6 months, I started it to let it run for 20 minutes before riding and noticed the check engine light on. I check and the reservoir for the coolant was empty. I filled it and the radiator and went for a 15 mile ride. The next morning the reservoir was empty again but saw no leaks on the concrete. Does anyone have any similar experience or what to look for?
 

·
Super Moderator
Joined
·
25,678 Posts
I would start by pulling all the plastic console panel. Check all the clamps. The factory clamps are bad about leaking. And if there's mud or dirty under the engine it will soak up the antifreeze and it will never hit the ground.
 

·
Registered
Joined
·
18 Posts
Mine is doing the same thing. I smelt antifreeze for a second, then nothing. Ordered a new Y fitting and will replace this weekend. I hope that is it
 
1 - 3 of 3 Posts
Top