Can-Am Commander Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I recently replaced my fuel pump on my 1000 Can am Commander and I'm not getting any power to the pump. I checked the fuse and the ground wire. The engine turns over but the fuel pump does not turn on. Thinking I may have had a bad pump I replaced it, but I'm still have power issues. Need advice.​
 

·
Registered
Joined
·
12,849 Posts
So do you have power at the pump . Did you test for power . As soon as you turn the key on the ecm sends a couple seconds of power to the pump
 
1 - 4 of 4 Posts
Top