Can-Am Commander Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
100 Posts
Discussion Starter · #1 ·
I just picked- up a 2011 commander 1000xt w/ rock guards, roof and visor, bed rails, half windshield, and rear screen. Upon start-up I'm getting the old owners name across the display. Does anybody know how to change this. Can't find it in the manual. Any info would be greatly appreciated.
 

·
Registered
Joined
·
313 Posts
AFAIK, that can only be done at the dealer. The good news is that it can be programmed to say anything you want it to say.

Best of luck - and congrats on your new toy! You're gonna love it. :)
 

·
Registered
Joined
·
222 Posts
takin mine in friday for service gonna c if they can change it for me mine says the dealers name
 

·
Registered
Joined
·
806 Posts
I think it is up to 26 characters maximum including spaces....we wanted 27 but was too many, so dropped it back to 24 and is OK....suggest you specify all caps as a few of our small letters are stupid looking
 

·
Registered
Joined
·
42 Posts
Mine says set down and hold on I'm a beast!!
 
1 - 6 of 6 Posts
Top