Does anyone know the size of the bolt that holds on the brake caliper? Not the long bolts that hold the pads in place, but the shorter hex bolts that hold the whole thing in place. is it 10mm or 12? My machine is at our mountain place and I need to buy a few down here in the flat lands before we head up.
That I don’t they are short . I will look out in the garage I have a bolt somewhere. I’m thinking the one I replaced I bought one that was to long and stacked a couple 3 flat washers a lock washer and loctite .
my guess would be 20mm. I took one off of a Yamaha Rhino to make it work last time up there so I'd like to get the correct length. I also used the washer trick when I did that. I'm going to buy a handful of extra so I don't get caught in the wheel explosion scenario I had last time!
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Can-Am Commander Forum
384.4K posts
21.1K members
Since 2009
A forum community dedicated to Can-am Commander side-by-side owners and enthusiasts. Come join the discussion about performance, accessories, specifications, modifications, troubleshooting, maintenance, and more!