[Rw593491]

Hello everyone. I finished putting this machine all back together. I never pulled the engine completely out, the only thing i've done to the engine is change oil, filter and spark plugs.
I was riding this thing in November its been sitting in my heated shop ever since. Now it only cranks wont start. I took the intake elbow off to confirm fuel flow, removed spark plugs to confirm spark, recharged the battery. I am stumped, it drove in and now nothing. any suggestion is appreciated thank you.

 

[cannedham]

I see you confirmed fuel flow, but wonder if it's enough. You might remove the air filter and spray fuel into the intake while cranking to see if it fires.

 

[jimclemjr]

Spark & fuel & air..... any chance a critter built a nest in intake or chew a hole in the duct after throttle body?

 

[Jwaite4270]

I have a 2018 commander 1000 limited and my is acting the same way. Except mine started after I ran it out of gas.. changed plugs, oil, and checked the spark and fuel flow.. it ran for just a few seconds after rolling over for a good bit... and by ran It hammered ! Anyone have any ideas

 

[acefire]

Check fuel pressure possible pump took dump when it ran out of fuel. Should be 50psi or higher key on running or not .