Can-Am Commander Forum banner

3x warranty + mod

1K views 3 replies 4 participants last post by  Irish 
#1 ·
Boxed in rear end and stuffed w/ insulation. Put metal plate over front/top/rear of unit and sealed it. Did NOT put sticky wrap so I can remove it for warranty work if someday needed because it overheated! Did quiet it down enough that I now notice the CVT noise!!!

Warranty:
1. Seat belt retractor (plastic clip that covers the retractor) broke. The BOMB decided you have to replace the whole seat belt. All is good.
2. Power actuator (pneumatic -sp?- tube) seized up on me. Getting new one. Pending but don't see any problems.
3. SEAT. Plastic pan that contours the foam bottom of the seat and bolts to the cage that holds the seat broke.
Drivers side, outside front corner split open and all the vinyl came loose. Said I get a new seat for warranty. Pending also, don't see any problems.

For what it's worth.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top