Can-Am Commander Forum banner

Grease fittings

11K views 6 replies 4 participants last post by  XTCntn 
#1 ·
I have located the following grease fittings:

3 on each of the right and left front A arms

2 on the front drive shaft U joints

2 on the rear drive shaft U joints.

Am I missing any?

Could any one tell me how they access the rear drive shaft front U joint fitting. I can't seem to get access to that U joint from any angle. It is too far forward to get at easily.

Thanks!
 
#6 · (Edited)
Here's what mine looks like with the cover off, and you still couldn't get to the zerk? I don't know what to tell ya. I don't think your taking the right panel off. When and if you take off the right panel, take note of the rub point circled in red. Put something around the radiator hose to protect it. Check for that shaft bolt too. Their known for coming loose and going bye bye. Mine was missing from the get go. I found it laying on the skid plate.

 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top